Fitted the floors. It took about six hours and three drill bits. I found that cutting the aluminum panels with a jig saw using the workmate worked very well. I opened up the table on the work mate and cut down the gap, that way both sides were supported. I also ground down some of the welds so that the floor panels would sit flat. It was quite simple to flip the frame over single handed, I flipped the frame over and rotated it ninety degrees so that the scuttle hoop was inside the work table.I found a set of S-10 wheels for a good price here in Tucson. They are the same style as used on the Super Stalker Prototype.